Procedure
1.
On the rear of the housing, there are two recesses. Place these
on the top edge of the DIN rail.
2.
Then press the housing against the DIN rail until the spring catch
of the device locks onto the lower edge of the DIN rail.
3.
Secure the cable for the power supply and the data and any other
cables required (for example for the signaling contact) according
to the descriptions in the section "Connecting up".
Removing
1. Remove all cables connected to the X-300.
2. Use a screwdriver to lever down the spring catch of the device and pull the lower part of the
device away from the rail.
3. Remove the device from the upper edge of the DIN rail.
5.5
Wall mounting
Wall mounting
1. For wall mounting, use suitable mounting fittings for the wall
(for example, for a concrete wall, four plugs 6 mm diameter and 30 mm long, 4 screws 3.5
mm diameter and 40 mm long).
2. Connect the electrical cable connecting cables.
Assembling
5.5 Wall mounting
SCALANCE X-300M PoE
Compact Operating Instructions, 11/2019, A5E02630810-13
35
Summary of Contents for SIMATIC SCALANCE X-300M PoE
Page 10: ...Introduction SCALANCE X 300M PoE 10 Compact Operating Instructions 11 2019 A5E02630810 13 ...
Page 12: ...Safety notes SCALANCE X 300M PoE 12 Compact Operating Instructions 11 2019 A5E02630810 13 ...
Page 74: ...Index SCALANCE X 300M PoE 74 Compact Operating Instructions 11 2019 A5E02630810 13 ...
