Installing the Device
2.5.2 Connecting External PoE Power
To connect an external power supply for the PoE ports, do the following:
NOTICE
Electrical hazard – risk of damage to equipment
Only connect the external PoE power supply to the terminals 5 and 7.
1. Remove the terminal block cover.
2. If a screw-type terminal block is installed, remove the screws from terminals
5 and 7. Use these screws along with #6 ring lugs to secure the wires to the
terminal block.
3. Connect the positive wire from the power source to terminal 5 (+/L) on the
terminal block.
3
4
3
4
1
2
3
3
1
1
Screw-Type Terminal Block
2
Pluggable Terminal Block
3
Jumper
4
Terminal 4 (Chassis Ground)
5
Terminal 5 (+/L)
6
Terminal 7 (-/N)
7
Chassis Ground Terminal
Figure 2.7
Terminal Block Wiring
4. Connect the negative wire from the power source to terminal 7 (-/N) on the
terminal block.
RUGGEDCOM RSG2100P
Installation Manual, 04/2022, C79000-G8976-1041-20
17
