Setting the KP8 and KP8F
6.3 Setting controller - communication HMI device
KP8, KP8F
60
Operating Instructions, 10/2010, A5E03284305-01
Procedure – Setting slot 1
1.
Double click in the properties window on slot 1.
The "Properties – KP8 inputs/outputs" dialog box opens.
2.
Open the "Addresses" tab.
In the "Inputs" and "Outputs" groups, the start values of the address areas are set
depending on the controller used.
Parameter
Meaning
Inputs > Start
Start of address range in which the PROFIsafe inputs/outputs for
the fail-safe HMI device are mapped.
Inputs > Process Image
Process image to which the address range belongs.
This parameter cannot be set with controllers of the
SIMATIC CPU 300 type.
Outputs > Start
Start of address range in which the PROFIsafe inputs/outputs for
the fail-safe HMI device are mapped.
Outputs > Process Image
Process image to which the address range belongs.
This parameter cannot be set with controllers of the
SIMATIC CPU 300 type.
3.
Change the entries, if required.
4.
Select the "Parameters" tab.
5.
Open the "Parameters > Device-specific parameters" folder.
Parameter
Meaning
Duration of the light test
The value range from 0 to 60 s can be set.
With the value "0", no light test is executed.
Default setting is 5 s.
Brightness
Adjustable:
very bright, bright, normal, dark or very dark
Default setting is "normal".
Function of the clamp 0
Adjustable:
Input or output, default setting is input
Function of the clamp 1
Adjustable:
Input or output, default setting is input
Function of the clamp 2
Adjustable:
Input or output, default setting is input
Function of the clamp 3
Adjustable:
Input or output, default setting is input
Function of the clamp 4
Adjustable:
Input or output, default setting is output
Function of the clamp 5
Adjustable:
Input or output, default setting is output
Function of the clamp 6
Adjustable:
Input or output, default setting is output
Function of the clamp 7
Adjustable:
Input or output, default setting is output
