Operating Instructions, 01/2021, A5E43920357-AA
71
Commissioning the device
4
4.1
Switching on the device
Requirement
•
The power supply is connected. (Page 59)
Procedure
1.
Switch the on/off switch (in case of redundant power supply: both on/off switches) on the
rear of the device (position | ).
2.
Press the on/off button at the front of the device behind the front panel door. Information
on the position of the switch and the button is available under "Operator controls
(Page 28)".
Commissioning the installed Windows® operating system
You can find information on first startup of the device and commissioning the installed
Windows® operating system in the documentation on the supplied data storage medium.
See also
Important instructions and manuals for operating the device (Page 11)
4.2
Configuring automatic switch-on of device
In the firmware settings, you can specify that the device starts up again automatically after
being disconnected from the supply voltage for up to two minutes as soon as the supply
voltage is available again.
The minimum downtime required for the supply voltage depends on the configuration of the
device.
Configure this function in the firmware settings:
1.
Select: "Advanced > Power > Restore AC Power Loss".
2.
Assign the "Always on" value to the firmware setting "Restore AC Power Loss".
See also
Important instructions and manuals for operating the device (Page 11)
