Siemens Simatic IPC520A, Operating Instructions Manual

Page: 40 / 80

Expanding the device
5.1 Installing the M.2 module
SIMATIC IPC520A
40
Operating Instructions, 11/2021, A5E51366325-AA
Procedure - Installing the M.2 module
Disconnect the device from the power supply.
Remove the retaining screws on the back cover of the
device.
Lift up the device's rear panel.
Align the golden finger of the M.2 module on the
motherboard, and then press firmly until it is completely
seated on the slot.
Secure the M.2 module with screw.
Note : Make sure the M.2 module board is located between
head and spacer of assembly screw.
If the M.2 module have some installation accessories such as antenna, you can do the following steps:
Connect the cables of M.2 module installation accessory to
the M.2 module.
Get the cable of M.2 module installation accessory out of
the housing through reserved antenna holes.
Note :
Use a screwdriver to pry open the reserved antenna holes.
Make sure that there are no iron scraps left on the
motherboard.
Procedure - Removing the M.2 module
Follow the above steps in reverse order to remove the M.2 module.