Installing and connecting the device
3.5 Mounting the device
Comfort Panels INOX, ITC INOX
20
Compact Operating Instructions, 08/2022, A5E33472156-AP
Mounting
CAUTION
Risk of injury when device falls
An unsecured device may fall. This can result in damage to persons, machines and the
device.
Secure the device against dropping during the entire installation.
1.
Insert the device with its mounting seal, clamping frame and all enclosed mounting clips
into the mounting cut-out from the front, as shown in the figure.
The tip of the setscrew must be inserted into the center hole as shown in the zoomed
section of the figure.
Material thickness
t
at the
mounting cutout:
•
With 7, 9, and 12" devices: 1.5 mm to 6 mm
•
With 15" and 19" devices: 1.5 mm to 5 mm
2.
Turn the setscrew of each mounting clip until a slight clamping force is perceptible.
After a few rotations a slight resistance will become perceptible. When the increase in force
is perceptible, tighten the setscrew of the next mounting clip. Perform this step for all
setscrews.
3.
Check that the mounting seal is properly seated.
–
The edge of the mounting seal must be flush and evenly flush with the stainless steel
front on all sides.
–
The edge may protrude 0.1 to 0.5 mm.
4.
Tighten the setscrew of the mounting clip until the fixed stop is reached and the torque
increases perceptibly. The tightening torque is then:
–
With 7, 9, and 12" devices: approx. 1.0 Nm
–
With 15" and 19" devices: approx. 0.5 Nm
