Servo Screen 390
36
E382 E394E 061 01 02 02
Siemens-Elema AB
4. Service procedures
4
Adjusting the support arm
The pre-tension in the joint as well as in the
rail clamp can be adjusted if necessary:
Joint
• Loosen the screw (1).
• Tighten or loosen the screw (2).
• Secure the new adjustment by tightening
the screw (1).
Rail clamp
• Loosen the screw (1).
• Turn the lever (2):
– Clockwise to increase the tension in the
clamp.
– Counter-clockwise to reduce the tension
in the clamp.
Note – The lever must be given either half
turns or full turns.
• Secure the new adjustment by tightening
the screw (1).
1
2
S
S-046X
S
S-045X
1
2
Summary of Contents for Servo Screen 390
