Servo Screen 390
E382 E394E 061 01 02 02
31
Siemens-Elema AB
4. Service procedures
4
Replacing the software
memory card
• Make sure that the Servo Screen 390 is
turned off.
• Remove the protective cover (1).
• Push the button (2) to release the software
memory card from the memory card slot.
• Pull out the software memory card (3).
• Put the desired software memory card
into the memory card slot. A mechanical
key on the card and in the slot prevents it
from being fully inserted in a wrong
position.
• Push the software memory card into the
slot. Mount the protective cover (1).
The software memory card is now replaced.
Perform a Functional check according to the
instructions in the Operating Manual.
There are two different versions of the
software memory card:
– PC Card™ used on Servo Screen 390
equipped with Computer board PC 1662.
– CompactFlash™ used on Servo Screen
390 equipped with Computer board
PC 1835. Note – As patient related T
RENDS
and unit related E
VENT
L
IST
are stored on
the CompactFlash-card, it is not
recommended to move a CompactFlash-
card between different units.
The procedure for replacing the software
memory card is the same for the two
different versions
1
3
S
S-041X
2
Summary of Contents for Servo Screen 390
