9
Instruction manual
| Types SDV-R and SDV-R-AR distribution circuit breakers
Important:
Do not move equipment from
the place it was set when unloading.
Also, do not remove or disturb packaging
or wrapping material prior to carrier
damage inspection. Equipment must be
inspected by carrier prior to handling
after receipt. This eliminates loss due to
claims by carrier that equipment was
damaged or further damaged on site
after unloading.
6. Be sure equipment is properly
protected from any further damage
by covering it properly after
unloading.
7. If practical, make further inspection
for possible concealed damage while
the carrier’s inspector is on site. If
inspection for concealed damage is
not practical at the time the carrier’s
inspector is present, it must be done
within 15 days of receipt of
equipment. If concealed damage is
found, the carrier must again be
notified and inspection made prior to
taking any corrective action to repair.
Also notify Siemens immediately at
+1 (800) 333-7421 or +1 (423) 262-
5700 outside the U.S.
8. Obtain the original of the carrier
inspection report and forward it along
with a copy of the noted delivery
receipt to Siemens at +1 (800) 333-
7421 or +1 (423) 262-5700 outside
the U.S. Approval must be obtained
by Siemens from the carrier before
any repair work can be performed.
Before approval can be obtained,
Siemens must have the above
referenced documents. The carrier
inspection report and/or driver’s
signature on the delivery receipt does
not constitute approval to repair.
Note:
Shipments are not released from
the factory without a clear bill of lading.
Approved methods are employed for
preparation, loading, blocking and tarping of
the equipment before it leaves the Siemens
factory. Any determination as to whether the
equipment was properly loaded or properly
prepared by shipper for over-the-road travel
cannot be made at the destination. If the
equipment is received in a damaged
condition, this damage to the equipment
must have occurred while en route due to
conditions beyond Siemens control. If the
procedure outlined above is not followed by
the consignee, purchaser or their agent,
Siemens cannot be held liable for repairs.
Siemens will not be held liable for repairs in
any case where repair work was performed
prior to authorization from Siemens.
Important:
Packaging materials could be
flammable. Do not expose packing material to
open flames or high temperatures. Disposal
regulations vary from locality to locality and
may be modified over time. Specific
regulations and guidelines should be verified
at the time of waste processing to ensure that
current requirements are being fulfilled. For
specific assistance in understanding and
applying regional regulations and policies or
manufacturer’s recommendations, refer to
the local Siemens service representative for
additional information.
and storage
