Siemens RUGGEDCOM RSG2100, Installation Manual

Page: 32 / 54

Chapter 3
Communication Ports
RUGGEDCOM RSG2100
Installation Guide
24 Fiber Optic Ethernet Ports
Section 3.2
Fiber Optic Ethernet Ports
Fiber optic Ethernet ports are available with either MTRJ (Mechanical Transfer Registered Jack), LC (Lucent
Connector), SC (Standard or Subscriber Connector) or ST (Straight Tip) connectors. Make sure the Transmit (Tx)
and Receive (Rx) connections of each port are properly connected and matched to establish a proper link.
2 1
Figure 19: MTRJ Port
1. Tx Connector 2. Rx Connector
2 1
Figure 20: LC Port
1. Tx Connector 2. Rx Connector
2 1
Figure 21: SC Port
1. Tx Connector 2. Rx Connector
2 1
Figure 22: ST Port
1. Tx Connector 2. Rx Connector
For specifications on the available fiber optic Ethernet ports, refer to Section 4.5, “Fiber Optic Ethernet Port
Specifications” .
Section 3.3
SFP Transceivers
The RUGGEDCOM RSG2100 features two Small Form-Factor Pluggable (SFP) transceiver sockets, which are
compatible with a wide array of SFP transceivers available from Siemens.
The following SFP transceivers are compatible with the RUGGEDCOM RSG2100. For more information, including
installation/removal instructions and ordering information, refer to the RUGGEDCOM SFP Transceiver Catalog
[https://support.industry.siemens.com/cs/ca/en/view/109482309] .
IMPORTANT!
Only use SFP transceivers approved by Siemens for RUGGEDCOM products. Siemens accepts no liability
as a result of performance issues related in whole or in part to third-party components.
SFP Transceiver Order Code
Speed
(Mbit/s)
Mode
a
Nominal Distance (km)
RUGGEDCOM SFP1112-1 6GK6000-8CG01-0AA0 10/100/1000
b
CAT-5e
Copper
0.1
RUGGEDCOM SFP1122-1SX 6GK6000-8FG51-0AA0 1000 MM 0.5
RUGGEDCOM SFP1122-1SX2 6GK6000-8FE58-0AA0 1000 MM 2
RUGGEDCOM SFP1132-1LX10 6GK6000-8FG52-0AA0 1000 SM 10