Siemens OP17, Equipment Manual

Page: 149 / 198

B-5
Equipment Manual OP7, OP17
Release 04/99
Remedy: Cause Mes-
sage
217,
218 Overlapping specified/actual values. Check configuration of actual/speci-
fied values in the process link.
219 Hardware fault: relay or port could not be set. Send unit for repair.
220 Print buffer overflow due to overload. Printout
not possible. Messages have been lost.
221 Print buffer overflow due to overload. Printout of
overflow messages not possible. Messages have been lost.
222 Warning: the event message buffer is full apart
from the specified remaining buffer space. Clear the buffer or configure a smal-
ler figure for the remaining buffer
space.
224 The event message buffer has overflowed. If a printer is connected and buffer
overflow has been configured, the
overflow messages will automati-
cally be printed out.
225 Warning: the alarm message buffer is full apart
from the specified remaining buffer space. Clear the buffer or configure a smal-
ler figure for the remaining buffer
space.
227 The alarm message buffer has overflowed. If a printer is connected and buffer
overflow has been configured, the
overflow messages will automati-
cally be printed out.
229 No keyboard connected (internal keyboard with
ribbon cable).
230 The minimum value is greater than the maximum
value for variable limits. Correct the limit settings.
231 The minimum value is equal to the maximum va-
lue for variable scales. Correct the scale on the OP.
303 Fault in connection with PLC.
S5: this error may occur when transferring large
data records. In such cases the watchdog is activa-
ted.
Check PLC status.
S5: set value in data word 98 to at
least 2000.
304 Illegal S5 job number or job parameters in a func-
tion field.
305 Data block number missing. Set up data block or change configu-
ration.
306 Incorrect CPU specified under ”PLC –> Parame-
ters”. Change configuration and retransfer.
307 ...
311 Variable not present on PLC Check configuration of process link.
312 The printer is already processing a print job and
can not accept this next job at present. Wait until the printer is free again
and repeat the print job.
313 Information message: print job completed.