3 Installation and Commissioning
Frei verwendbar House Control with Master-Slave - LOGO! Set 9
Entry ID: 64143308, V2.2, 09/2018
19
©
S
ie
m
e
n
s
A
G
2018
A
ll
r
ig
h
ts
r
e
s
e
rv
e
d
3.3
Commissioning
Note
Changes of the IP address or the master-slave mode are only possible in
"STOP” mode.
3.3.1
Assigning IP addresses to LOGO! devices and setting the
master/slave mode
Table 3-1
No.
Action/response
LOGO! display
1.
First, configure the master LOGO!.
Go to the "Network” item via the LOGO!
display
using the cursor keys C1▲ or C2▼ on
the LOGO! 8 and press OK.
2.
Select "IP address”.
3.
Press the OK button of the LOGO! controller
and use the cursor keys C1▲, C2▼, C3 ◄
and C4 ► to enter your master LOGO!’s IP
address (here: 192.168.1.10).
Confirm with the OK button.
4.
Press the ESC key to return to the previous
menu item and select "Set M/S mode”.
5.
For configuring the master LOGO!, select
"Master”.
6.
Repeat steps 1-5 for the configuration of the
slave LOGO!, with the following differences:
•
IP address, here: 192.168.1.11
•
"Set M/S Mode” -> "Slave”
7.
Enter the IP address of the master LOGO! you
want to connect to the slave LOGO! and press
the OK button.
8.
The LOGO! controller will automatically reboot
and then display the main menu. The
master/slave configuration is now complete.