Siemens HiPath 1120, Programming Manual

Page: 17 / 180

Main Configurations
17
Step by Step
Main Configurations
Some settings may be modified right from the begin-
ning. In most cases, however, we recommend using
the default settings. If you need to change any settings,
see the following chapters:
Dialing Mode on an External Analog
Line
This features specifies the dialing mode to be used over
an external analog line (DP or MF).
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
Enter a number for an external analog line (e.g., 801).
... Enter the appropriate code:
= Analog line: Pulse dialing (DP)
= Analog line: Multifrequency tone dialing (MF)
(default
for all analog lines)
Enter the next external line number.
or
Press this key.
Initial state for Programming Mode.
Default Access to a Group of External
Lines
This feature configures the access method to be used
for a group of external lines. The default external line
access code is "0."
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
Enter the extension number (e.g., 11/101).
1 9
1 2
1
2
#
0 0 2