Siemens HiPath 1120, Programming Manual

Page: 121 / 180

Programming a Digital Trunk
121
Step by Step
The selected external line is deleted.
... Enter the next MSN slot
or
Press this key.
Initial state for Programming Mode.
TME1 Module
The E1 CAS access provides Caller ID and Direct Dialing
to Extensions facilities to help reduce call loss rate and
make it easier to access the user. The HiPath 1130 and
the HiPath 1150 can be equipped with one TME1
module (configured for up to 15 channels). The
HiPath 1190 can be equipped with two TME1 modules.
When E1 digital lines are being used, only the External
Number Phonebook needs to be programmed. Country
Code and Area Code can be left blank.
Note:
• Country Code and Area Code are never sent to the
public exchange.
*
0 1 0 4 0 1
#
When the total number of digital trunks config-
ured for the module plus the number of external
analog lines exceed the maximum capacity of
the system, the external analog lines for the EB
202, 206 and 210 expansion modules are
disabled. The extensions, however, will continue
to work as usual. The lines are disabled in the
order they are physically installed (1, 2...). This
continues until the total number reaches the
required number of trunks. The remaining
modules continue operating as usual.
However, in the case of the EB 200, 400 and 800
modules, it is strongly recommended that you
change their slots to prevent their deactivation.
These modules become inoperable if any one of
their external line slots is disabled.
The S
0
and TME1 modules as well as the ADSL
and TME1 modules cannot operate simulta-
neously on the HiPath 1130.