Siemens HiPath 1120, Programming Manual

Page: 118 / 180

Step by Step
Programming a Digital Trunk
118
Press this key.
Initial state for Programming Mode.
Mode of Operation
This setting specifies the type of connection, either
Point-to-Multipoint or Bus S
0
, between the system’s
digital lines and the local carrier’s lines.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
, , or Enter the S
0
Module slot on the system
1
.
Enter the slot for the S
0
module slot:
or
= for HiPath 1120;
... = For HiPath 1130/1150;
... = For HiPath 1190 (for the second
module use Slot 11 and Port 00 to... 04).
... Select the type of connection for the external digital
line.
= Point-to-Point (PP - default for the first port)
= Point-to-Multipoint (PMP)
= Bus S
0
connection (default for all other ports) only
for HiPath 1130/1150 or HiPath 1190
Enter the next module slot
or
• Press this key.
Initial state for Programming Mode.
#
9 0
0 1 0 2 0 3 1 1
1.Enter the slots for the modules: HiPath 1120 (02), HiPath 1130/1150
(03), and HiPath 1190 (01 and 11).
0 0 0 1
0 0 0 4
0 0 0 4
1 3
1
2
3
#
HiPath 1120 cannot be programmed as S
0
Bus.
With other systems, the first port may also be
configured as an S
0
bus.