Siemens Gigaset S100, User Manual, Page: 116 / 137

112
Appendix
Gigaset S100 /S150 / englisch / A31008-S100-J102-1-7619 / appendix.fm / 23.06.2003
… (if several handsets are
used) the handset in the base
station does not charge?
A handset cannot be charged
while a telephone call is being
made.
Use an additional charging
unit.
... the handset or the base sta-
tion S 150 does not ring?
The ringer tone is switched off.
Call diversion has been set to
All
Calls
.
Activate the ringer tone of the
handset (page 96) or the base
stationS 150.
Switch off call diversion
(page 2).
... I cannot hear any ringer/
dialling tone?
You have changed the telephone
cord on your Gigaset.
Ensure, when purchasing a
new cord, that it has the cor-
rect pin assignment (page 8).
... the units/call charges are
not displayed?
There are no metering pulses. Ask your network provider to
transmit the metering pulses.
... the call charge is not dis-
played?
The charge per unit set to
"00.00".
Set call charge per unit
(page 4).
... the other person cannot
hear me?
You have pressed the
u
(INT)
key. This "mutes" the handset.
Re-activate the microphone
(page 22).
... the incoming call number is
not displayed although CLIP is
set?
The calling line identification is
not enabled.
The caller should permit call
line identification (CLI) by his
or her telephone company.
... the error beep is heard
while making an entry (rising
tone sequence)?
The action has failed or the input
is incorrect.
Repeat the procedure; read the
display message and, if neces-
sary, refer to the operating
instructions.
… I cannot listen to the net-
work mailbox?
Your PABX system is set to dial
pulsing.
Switch the PABX system to tone
dialling (page 110).
... an answering machine
message does not have a time
stamp?
The date/time are not set. Set the date/time (page 15).
... the answering machine
says ”PIN is incorrect” during
remote operation?
The system PIN entered is incor-
rect or still set to 0000.
Re-enter the system PIN or set a
PIN other than 0000
(page 102).
... the answering machine
does not record any messages
or has automatically switched
to announce only mode?
Its memory is full. Delete old messages.
Play back and delete new mes-
sages.
... voice command does not
work?
You are too far from the handset:
The background noise is too
loud.
Reduce the distance to handset
to about 20 cm.
Record your voice patterns in
quieter surroundings.
What has happened if ... Possible cause Possible solution