6
Smart Infrastructure
A6V13605540_en--_b
Smart Infrastructure
2022-10-14
Mounting
The Connect Box can be snapped onto standard rails or screwed onto the wall.
Plug-in screw terminals connect power and interfaces.
Do not install the device in the following locations:
●
Where there is excessive moisture, corrosive fumes, or explosive vapors.
●
Where vibration or shock is likely to occur.
●
Where the device is subject to electrical noise, e.g. near large electrical contractors,
electrical machinery, welding equipment, etc.
●
When the device is mounted inside a cabinet, make sure the cabinet is designed to
maintain the required operating temperature range (allowing for 24 watts of dissipation
by the controller). This is especially important if the device is mounted inside an
enclosure with other heat-producing equipment.
●
More than 2 meters above ground to avoid any risk of injury caused by a fall.
●
Where children are likely to be present.
In an outdoor locations.
Installation
WARNING
Electric shock
Incorrect installation of the device may lead to electric shock injuries when touching the
device!
●
Install the device in a lockable cabinet or use terminal covers.
●
Do not install the device in locations where children are likely to be present.
●
Conductors with a cross-section of 0.5 mm2 (AWG24) or greater shall comply with the
requirements of IEC 60332-1-2 and IEC 60332-1-3 or IEC TS 60695-11-21.
NOTICE
Radio frequency energy
Interference to radio communications
●
Install and use equipment in accordance with installation guide.
●
Read all regulatory compliance information.
Disposal
The device is considered an electronic device for disposal in accordance
with European Directive and may not be disposed of as domestic waste.
●
Use only designated channels for disposing the devices.
●
Comply with all local and currently applicable laws and regulations.
●
Dispose of empty batteries at designated collection points.
