Siemens BA 2030 SERIES, Operating Instructions Manual

Page: 74 / 166

Service and maintenance
8.2 Checking and changing lubricants
BA 2030
72
Operating Instructions, 11/2017, A5E37880173A/RS-AE
8.2.6 Changing the oil
8.2.6.1 General safety notes for changing the oil
NOTICE
Impermissible mixing of oils leads to damage
Impermissible mixing of oils leads to:
•
Darkening
• Sediment
•
Foam formation
• Change of the viscosity or reduced corrosion protection
•
Wear protection.
When changing oil of the same type, the residual volume of oil in the gearbox should be
kept as low as possible. Generally speaking, a small residual volume will cause no
particular problems.
Gear oils of different types and by different manufacturers must not be mixed. Have the
manufacturer confirm that the new oil is compatible with the remaining volume of used oil.
If very different types of oil or oils with very different additives are changed, always flush out
the gearbox with the new oil. When changing from mineral oil to polyglycol oil (PG) or vice
versa, it is vital to flush the gearbox twice. All traces of old oil must be completely removed
from the gearbox.
NOTICE
Contaminations of the oil impair the lubricity
Do not mix the gearbox oil with other substances.
Do not flush with paraffin or other solvents, as traces of these substances will always
remain inside the gearbox.
Note
The oil must be warm because insufficient viscosity caused by oil that is too cold impairs
correct emptying.
If necessary, run the gearbox for 15 to 30 minutes to become warm.