GAMMA
instabus
Technical Product-Information
August 2017
Control Module Box AP 118
5WG1 118-4AB01
Technical Manual
AP 118, page 6 / 6
Siemens AG
Infrastructure and Cities Sector, Building Technologies
Update: http://www.siemens.com/gamma
© Siemens AG 2017
Control Products and Systems
Subject to change without further notice.
P. O. Box 10 09 53, D-93009 Regensburg
2.4.2.11/6
Disconnecting bus cables
- Unplug the bus connection block (D1) and remove the
bus cable conductor (D2) while simultaneously wig-
gling it.
D2
D2.4
5 mm
D2
D2.4
25...35 mm
D1
figure 10: Connecting / Disconnecting bus cables
Connecting/disconnecting mains and load circuit:
Connect wires
-
The load circuits are connected via screwless plug-in
terminals (E1).
-
Remove approx. 9…10 mm of insulation from the wire
(E 1.1) and plug it into the terminal (E1).
-
The terminals are designed for connection of two wires
allowing to loop through the terminal block.
Note:
The maximum permissible terminal load current is 16A.
Remove wires
-
Press the terminal interlocking of the terminal (F1)
with a screw-driver and remove the wire (F2) from the
terminal (F1).
E1
F1
F2
figure 11: Connecting/disconnecting mains and load
circuit
Dimension drawing
Dimension in mm
General Notes
∂
The operating instructions must be handed over to the
client.
∂
Any faulty device is to be sent together with a return
delivery note of the local Siemens office.
∂
For any technical questions, please consult:
&
+49 (911) 895-7222
6
+49 (911) 895-7223
)
www.siemens.com/automation/support-request
