Siemens AP 118, Technical Product Information

Page: 3 / 6

GAMMA instabus
Technical Product-Information
August 2017
Control Module Box AP 118 5WG1 118-4AB01
Siemens AG AP 118, page 3 / 6 Technical Manual
Infrastructure and Cities Sector, Building Technologies
Control Products and Systems
© Siemens AG 2017 Update: http://www.siemens.com/gamma
P. O. Box 10 09 53, D-93009 Regensburg Subject to change without further notice.
2.4.2.11/3
A1 Product label
A2 Hole for screw fastening of Control Module Box
A3 Screws for securing the lid
A4 Latching clamp for locking the lid
A5 Control Module Box, Lid
A6 Hinge for lid
A7 Bushing for BUS cables (with strain relief)
A8 Bushing for low voltage cables (with strain relief)
A9 Control Module Box, base
A10 Bus terminal
A11 Mounting location for one RS / RL module
A12 RS module (to be ordered separately)
A13 RL module (to be ordered separately)
A14
Clamp for strain relief (cut off from base)
A2
A14
A7
A6
A11
A9
A4
A2
A14
A8
figure 2b: Mounting
∂
Removing the lid of the Control Module Box:
- Remove the screws (A3) securing the lid.
- Pull the latching clamp (A4) away from the lid (A5), lift
the lid up, swivel it up and remove it from the hinge
(A6).
∂
Mounting the lid of the Control Module Box:
- Hook the lid (A5) into the hinge (A6).
- Push the lid (A5) down until it audibly snaps into the
latching clamp (A4).
- Fasten the screws (A3) to secure the lid.
A10
figure 3: Removing/Mounting the lid of the Control
Module Box
∂
Mounting / Dismounting of RS /RL modules:
A RS module (A13) or an RL module (A14) may be in-
stalled at the mounting location (A12) of the Control
Module Box. Mounting of the RS and RL modules is de-
scribed generically in these mounting and operating
instructions.
Notes on wiring and commissioning of specific modules
may be found in the respective documentation for that
module.
A1
A12
A10
A14 A7
A13
A9
A14
A8
figure 4: mounting / dismounting of RS/RL modules