Troubleshooting
7.2 Restoring the factory settings
SCALANCE S615
62
Operating Instructions, 10/2022, C79000-G8976-C389-07
7.2
Restoring the factory settings
NOTICE
If you reset, all the settings you have made will be overwritten by factory defaults.
NOTICE
Inadvertent reset
An inadvertent reset can cause disturbances and failures in a configured network with
further consequences.
With the SET button
When pressing the button, make sure you adhere to the instructions in the section "SET
button (Page 28)".
To reset the device to the factory defaults during the startup phase, follow the steps below:
1.
Turn off the power to the device.
2.
Press the SET button and reconnect the device to the power supply while holding down the
button.
3.
Hold down the button until the red error LED "F" stops flashing after approximately 10
seconds and is permanently lit.
4.
Release the button and wait until the fault LED "F" goes off.
The device starts automatically with the factory settings.
With SINEC PNI
Follow the steps below to reset the device parameters to the factory settings with the SINEC
PNI:
1.
Select the device whose parameters you want to reset.
2.
Click the "Reset device" button.
3.
Select the "Reset to factory settings" option in the following dialog.
Via the configuration
You will find detailed information on resetting the device parameters using the WBM and CLI
in the configuration manuals:
•
Web Based Management, section "Restart"
•
Command Line Interface, section "SET and Defaults"
