Wiring the power supply
The 24 V DC incoming supply is located at the bottom of the module and is built with a two-
pin male connector and a two-pin plug-in female connector. The female connector is inserted
from below.
'&
0
9
/
;
0DVV
9'&
0 /
Figure 6-4
Power supply for Compact FF Link
The maximum conductor cross-section is 2.5 mm
2
.
Note
Strain relief
A strain relief is not present for the power supply cables. During installation, you must ensure
that a strain relief for the supply cables is guaranteed.
See also
Wiring the Compact FF Link for non-redundant mode (Page 34)
6.5
Connecting PROFIBUS DP on Compact FF Link
Tools required
You need a suitable screwdriver to fasten the bus connector to the Compact FF Link.
Bus cable and connector
Use only the specified accessories for PROFIBUS DP.
Connecting
6.5 Connecting PROFIBUS DP on Compact FF Link
Compact FF Link
38
Operating Instructions, 03/2015, A5E35651552-AA
