Siemens 6DR2410, Manual

Page: 145 / 276

Manual 3 Operation
3.3 Configuring Mode (Parameterization and Configuring Mode)
3.3.2 Parameterization Mode AdAP (Adaptation)
SIPART DR24 6DR2410
C79000-G7476-C153-03
143
D
Adaptation error messages
no exit manual mode during adaptation
⇒
MAnual
YbL direction--dependent blocking operation via
MoDE the control signals
⇒
n Tracking mode via the control signals
⇒
MoDE
ovEr
>
10 % overshoot of the transient function
Shot
⇒
accurate adaptation not possible
too because of too small a line time constant
FAST accurate adaptation not possible
Pv x outside the measuring span 0 to 100 %
⇒
oFL
no at 67 % tU full scale value not reached
End
⇒
tU too short
⇒
loop cannot reach full scale value,
e.g. integrally active line
⇒
transient recovery time t
95
>
12 h
too x after 50 % tU still within starting band
SMAL
⇒
tU too short
⇒
y step too small
ALL step response in wrong direction within
PASS 30 % tU
⇒
Change active direction of the controller
⇒
control loop undershoot (all pass loop),
all--pass loops not defined among
loop models
Y y outside the measuring span of 0 to 100%
⇒
oFL
no after expiry of Ty the y step has not been
dY performed correctly for the S-controller
⇒
Error
message Explanation
dd1 dd2
y
Manual

Δ
y too big or too small
Check position feedback and drive of the
final control element
y
Manual

Δ
y too big or too small
(transient recovery time t
95
< 5 s)
cancel mode of operation
-10 0
y
% tU
not not stable at 10 % tU after
StAt start of adaptation
⇒
wait and restart adaptation
-10 0
y
% tU
30
100
x, y
x, y
100
-10 0
y
% tU
50
100
x, y
-10 0
y
& tU
67
100
x, y
-10 0
y
% tU
67
100
x, y
Table 3-2 Adaptation error messages