Add-on
modules
Installing memory modules
2
1
Insert the memory module at an angle into the appropriate location (1).
Ensure that the key notch and the two holes are correctly aligned with the
retaining pins.
Tilt the module down until it snaps into place (2).
Removing a memory module
2
1
1
3
Carefully push the retaining clips at each end of the module outwards (1).
Tilt the memory module forwards (2), and pull it upwards and at an angle out of
the mounting location (3).
A26361-D858-Z120-6-7619
41
Add-on modules
Replacing the processor
3
2
1
A
4
5
Push the lever in the direction of the arrow (1) and lift it as far as it will go (2).
Remove the old processor from the socket (3).
Insert the new processor in the socket so that the mark on the upper side of the
processor matches the mark (A) on the socket (4).
!
The mark on the processor may be covered by a heat sink. In this case let
yourself be guided by the marking in the rows of pins on the underside of
the processor.
Push the lever back down so that it snaps into place (5).
Depending on the processor which you have installed you must insert the
jumpers.
42
A26361-D858-Z120-6-7619
