Settings and add-on modules
On-Board IDE Drive
Any entry in this field is not applicable if the
Programming Option
field contains
the entry
Auto
.
This field allows you to enable or disable the hard disk drive controller on the
system board.
Possible entries:
Enabled
The hard disk drive controller is enabled.
Disabled
The hard disk drive controller is disabled.
Default entry:
Enabled
First Serial Port Address
Second Serial Port Address
Any entry in this field is not applicable if the
Programming Option
field contains
the entry
Auto
.
This field enables you to set the first and second serial port.
Possible entries:
3F8H
The serial port is set to the address 3F8H and to IRQ4.
3E8H
The serial port is set to the address 3E8h and to IRQ4.
2F8H
The serial port is set to the address 2F8H and to IRQ3.
2E8H
The serial port is set to the address 2E8H and to IRQ3.
DISABLED
The serial port is disabled.
Default entry:
3F8H
A26361-D818-Z120-1-7619
19
Settings and add-on modules
Parallel Port Address
Any entry in this field is not applicable if the
Programming Option
field contains
the entry
Auto
.
This field enables you to set the parallel port.
Possible entries:
378H
The parallel port is set to the address 378H and to IRQ7.
278H
The parallel port is set to the address 278H and to IRQ5.
3BCH
The parallel port is set to the address 3BCH and to IRQ7.
DISABLED
The parallel port is disabled.
Default entry:
378H
IRQ active State
This field enables you to specify whether the interrupt signals are high or low.
Possible entries:
High
or
Low
Default entry:
High
Parallel Port Mode
Any entry in this field is not applicable if the
Programming Option
field contains
the entry
Auto
.
This field enables you to set the transfer mode for the parallel port. The
parallel port supports extended transfer in accordance with EPP and fast
transfer in accordance with EPP.
Possible entries:
Normal
The parallel port can send only.
Extended
The parallel port can send and receive.
Default entry:
Normal
20
A26361-D818-Z120-1-7619
