Operating manual
–
Rotating table
4 Transport
12 / 15
4.3
Mounting and removing perforated plate
To mount the perforated plate:
−
Choose fitting fixture points for each perforated plate (according to the figure below)
▪
16
: Fixture points for system 16
•
all cleared sizes of perforated plates
▪
22&28 (<1500x1000
): Fixture points for systems 22 and 28
•
Size of perforated plate: smaller than1500x1000 [mm]
▪
22&28 (1500x1000):
Fixture points for system 22 and 28
•
Size of perforated plate: 1500x1000 [mm]
−
Move the perforated plate to the rotating table using suitable transport equipment (e.g. crane).
−
Position the perforated plate centrally above the rotating table.
−
Slowly lower the perforated plate.
−
When the perforated plate is located immediately above the adjustment screws where it will be attached,
pull the perforated plate to the precise position by hand if necessary.
−
Set the perforated plate down onto the adjustment screws.
−
Secure the mounting screws on the adjustment screws.
−
The perforated plate should remain secured to the transport equipment until the perforated plate has been
securely attached.
−
Use the adjustment screws to precisely adjust the perforated plate so that it is as horizontal and level as
possible.
To remove a perforated plate:
−
Remove all components from the perforated plate.
−
Attach the transport bracket(s) to the perforated plate.
−
Insert slings through the transport bracket(s).
−
Raise the transport equipment until the rotating gear is slightly tensioned and then secure the perforated
plate to the transport equipment.
−
Undo all mounting screws securing the perforated plate to the adjustment screws.
−
Lift off the perforated plate.
WARNING
•
Avoid rotating off at an angle; the pulling force must be applied vertically upwards.
•
Avoid swinging and rocking when rotating and transporting.
