Last update: 17.12.2014
25
Assembly instructions
MHS400
Preparing for cable installation in the sash groove at the top
Important note:
With some profiles with guide rail at the top, the cable holders can rub against the guide rail when the
lift & slide sash is lifted. Actions for avoiding this are described below.
Timber elements
• For timber profiles with
guide rail HH 0130-01/-02
, the cable can be routed through the glazing rebate.
• Alternatively, the sash groove can be milled 5 mm deeper on the horizontal sash timber at the top.
The bearing surface of the guides must not be altered!
• In the case of retrofitting, flat washers (Ø 20 mm) and nails (max. 30 mm long) must be used to secure the cable in the sash
groove at the top (see Fig. 1). Care must be taken to avoid damaging the wires of the cable with the nails.
obere Führungsnut
1
Flat washer (Ø 20 mm)
Nail (max. 30 mm long)
Flat ribbon cable (6-wire)
Sash groove at top
Timber element with guide rail HH 0130-01/-02
PVC elements
• With certain PVC profiles (see Chapter 4), the webs of the cable holders must be removed (e.g. with pliers or similar, see Fig. 2).
2
