Last update: 17.12.2014
17
Assembly instructions
MHS400
2.2 Information about mains cable fitting
Important information for safety and assembly
The fitting of the mains cable is determined by the prevailing conditions on site. There are two assembly options:
Option A — Surface-mounted fitting of mains cable
The MHS400 system is delivered as standard with a 5 m long mains cable for scheme A
and a 3.5 - 5 m long mains cable
for scheme C (depending on the width of the element). The cable outlet for scheme A is always at the top of the slide drive
SA on the locking side (Fig. 1); for scheme C, it can be located on the outside of the slide drive SA on either the left-hand
side or the right-hand side. A notch for the cable outlet must be made on the cover cap SA of the cover profile SA (see Fig.
2). A suitable mains socket must be located near the cable outlet. It is recommended to feed the mains cable through an
appropriate installation duct.
1
2
Cover cap SA delivered
with punched groove
for cable outlet aperture
notch
Using a suitable tool
(pliers or similar), carefully
remove the cable outlet
aperture notch.
Cable outlet aperture
notch
for mains cable
