Siegenia KFV BS 6000, Assembly Instructions Manual

Page: 63 / 64

H39.MFVRS009EN-00 02.2019 63 / 64
Assembly instructions Multi-point locks, key operated
BS 6000 OF/OR, BS 6000, BS 6600
8 Troubleshooting
8.1 Functional disorder of the lever handle (BS 6000, BS 6600)
The lever handle does not return to its original position by itself.
f
Check that the lever handle is correctly seated.
• The lever handle must not have any contact with the rose or the plate or the gear box.
f
Check the tightening torque of the screwing of the handle set.
• If the screwing is too tight, the routed pocket could be distorted and exercise lateral pressure on the gear box,
causing sluggishness.
f
Check the dimensions of the routed pocket of the main lock.
• If, in spite of the specified dimensions being observed, the lever handle does not return to its original position
by itself, the multi-point lock must be checked by KFV.
• If the routed pocket does not comply with the specified dimensions, it must be reworked.
f
Repeat the test step with the reworked routed pocket.
• If the lever handle continues to fail to return to its original position by itself, the multi-point lock must be che-
cked by KFV.
8.2 Functional disorder of the profile cylinder
The key cannot be pulled out.
f
Dismount the cylinder lock and check for functional disorders.
• The cylinder lock must be replaced if it does not function properly.
f
Repeat the test step with the new cylinder lock.
• If the key still cannot be pulled out, the multi-point lock must be checked by KFV.
8.3 Sluggishness during locking and release
f
Check the adjustments of the AT piece, the Q / G adjustments and the adjustment piece of the bottom bushing
(see chapter 6 „Performing the adjustments“ from page 53 ).
• Adjust the AT piece, the Q / G adjustment in the direction of the door leaf to reduce the lateral contact pressu-
re.
f
Repeat the test step with the readjusted settings.
• If this sluggishness persists, the dimensions of the routed pockets must be checked.
• When the routed pockets are compliant with the specified dimensions and the sluggishness persists, the multi-
point lock must be checked by KFV.
• If the routed pockets do not comply with the specified dimensions, they must be reworked.
f
Repeat the test step with the reworked routed pockets.