SIEB & MEYER FC2, Manual

Page: 39 / 73

25-pole male submin D connector
X30 Pin I/O Name Meaning
1 I IN0 Switch on
2 I IN1 Start / Stop
3 I IN2 Error reset
4 I IN3 Speed direction
5 I IN4 Configuration 1/2
6 I IN5 External hardware OK
7 n.c.
8 n.c.
9 O UA+ Speed pulse , 6 pulses per motor revolu‐
tion
10 O UA- Speed pulse output -, 6 pulses per motor revolu‐
tion
11 I/O GND Ground
12 I/O GND Ground
13 I/O GND Ground
14 O OUT0 Programmable digital output 1
15 O OUT1 Programmable digital output 2
16 O OUT2 Programmable digital output 3
17 O OUT3 Programmable digital output 4
18 O OUT4 Programmable digital output 5
19 O OUT5 Programmable digital output 6
20 n.c.
21 n.c.
22 n.c.
23 I PTC0 Do not wire
24 O +24V
25 O +24V
Stud bolt flange: max. tightening torque = 0.7 Nm
Related topics
Connection examples: "X30 – Digital Inputs / Outputs", page 53
8.9.1 Inputs
Switch on
When this input is activated, the control of the frequency converter is connected to
allow power transmission to the motor. The holding current is activated, if programmed.
The motor will be accelerated as soon as the start signal and a corresponding refer‐
ence value are received.
Start / Stop
The function input “Start/Stop” permits the start or stop of the frequency converter.
▶ Start = +24 V
▶ Stop = 0 V
W
Connectors
FC2 - Frequency converter 02192100xy 39
8