8
SE 60/185S ignition protected thruster assembly
1.0 - 2007
1. Remove the 4 bolts in the motorbracket (Fig 1).
2. Use the enclosed template to measure taht the driveshaft has come through the motorbracket with the correct hight (Fig 2).
3. Place the motor assembly gently on the motorbracket. Make sure that the drive pin in motor drive shaft fits the into the
corresponding grove in the gearleg shaft. Be careful, the motor is heavy!
4. Fasten the motor assembly to the bracket with the 4 bolts and cross tighten them first with 15Nm (11lb/ft) and then with 33Nm
(24lb/ft).
NB !
Paint the gearhouse and propeller with antifouling for propellers to prevent growth of barnacles or similar which would reduce the
performance dramatically. Do not paint the propeller shaft, the zincanodes or the end face of the gearhouse.
NB !
Do not run the thruster for more than very short bursts without being in the water.
Fitting the electromotor IP assembly
Fig. 1
Fig. 2
