- 15 -
12 - REPLACEMENT OF THE SPRING
12.5
12.6
12.7
12.7
12.9
WARNING! The disassembly of the spring is only permitted to the staff au-
thorized and suitably trained by the manufacturer. Handle with the greatest
care the spring; serious accidents might occur.
12.1) Take out the hose stop-
per and rewind slowly
the hose inside the hose
reel, so that the spring
is fully unloaded.
12.2) Loosen the swivel joint.
12.3) Loosen the two screws
of the spring linka-
ge shaft by a 10 mm
wrench.
12.4) Disassemble the 4
screws which lock the
two side bodies. Take
out the body side and
the rollers support and
draw out the drum.
12.5) Take out the shaft from
the spring housing.
12.6) Lift the tangs on the
drum by a screwdriver
and rotate the spring
housing centre in order
to release it from the
drum.
12.7) Turn upside down the
drum and take out the
spring housing centre
paying the greatest care
so that the spring does
not go out of it.
12.8) Insert and hook the shaft
into the new spring hou-
sing centre.
Lubricate the spring and
the shaft.
12.9) Put the drum straight
and place the new spring
housing centre with the
utmost care.Block the
tangs.
12.10) Assemble all the
parts and go on as indi-
cated at point 7.2 of the
chapter "Mounting of the
hose"
The spring which allows to rewind the hose is placed inside a proper housing centre which
is joint to the drum.
GB
12.4
12.1
12.2
12.3
