SICK VMS6200, Operating Instructions Manual

Page: 55 / 84

COMMISSIONING 6
55
80251340/2020-02-03|SICK
Subject to change without notice
T R A N S L A T I O N O F T H E O R I G I N A L O P E R A T I N G I N S T R U C T I O N S | VMS6200
If no dimensions can be calculated, this may be because the system parameterization
does not match the physical conditions.
▸
Check the trigger control settings in the MSC800. The trigger must be set to
Active Low .
▸
Check whether the encoder parameters entered for the MSC800 are consistent with
the VMC800 parameters.
▸
Check the configuration of the master LMS . The master LMS must receive the encoder
signal.

Check that the time stamp has been activated.
6.6 Optimizing the measurement results
If necessary, the measurement results can be optimized even further.
The length measurement (x-coordinate) is adjusted by changing the encoder resolution in
the
Encoder Resolution field under ALISDIM

Parameter

Increment Configuration .
•
If the measurement result is greater than the actual length value, reduce the resolution
(e.g., by 0.05 mm).
•
If the measurement result is smaller, increase the resolution accordingly.
The width measurement is adjusted by changing the y-coordinate for the volume
measurement devices under
ALISDIM  Parameter  External Sensors
.
• If the measurement result is smaller than the actual width value, reduce the
Y coordinate of
Sensor 1
and
increase
the Y coordinate of
Sensor 2
.
• If the measurement result is greater, do the opposite.
▸
NOTE! Adjust the two sensors symmetrically by decreasing or increasing the
Y coordinate of each by the same value.
▸
When adding/subtracting, pay attention to the signs of the Y coordinates.
The width measurement is adjusted by changing the Z coordinate for the volume
measurement devices under
ALISDIM

Parameter

External Sensors .
• If the measurement result is smaller than the actual height value,
reduce
the
Z coordinates of both sensors by the same value.
• If the measurement result is greater,
increase
the Z coordinate.
If no dimensions are
calculated
Optimizing the length
measurement
Optimizing the width
measurement
Notes
Optimizing the height
measurement