SICK PowerProx Mini WTT4SLC, Operating Instructions Manual

Page: 28 / 200

4.3 Mounting the device
Figure 3: Sensor alignment
Figure 4: Standard direction
1. Mount the sensor using a suitable mounting bracket (see the SICK range of
accessories).
2. Note the sensor’s maximum permissible tightening torque of 0.8 Nm.
3. Align the sensor with the object. Select the position so that the red emitted light
beam hits the center of the object. You must ensure that the optical opening (front
screen) of the sensor is completely clear.
see figure 3, page 28
4. Note the preferred direction of the object relative to the sensor. see figure 4,
page 28
5 Electrical installation
The sensors must be connected in a voltage-free state. The following information must
be observed, depending on the connection type:
– Male connector connection: Pin assignment
– Cable: Wire color
Only apply voltage/switch on the voltage supply once all electrical connections have
been established.
OPERATING INSTRUCTIONS
28 O P E R A T I N G I N S T R U C T I O N S | PowerProx Mini - WTT4SLC 8022570.1FBN/15.09.2022 | SICK
Subject to change without notice
en