SICK Bulkscan, Operating Instructions Manual

Page: 49 / 112

O P E R AT I N G I N S T R U C T I O N S | Bulkscan® 8014829/ZV98/2018-05-07| S I C K
Subject to change without notice
4 9
ELECTRICAL INSTALLATION
Pin Wire color Signal Function
3 White OUT1 Digital output 1
1 )
4 Green GND RS GND serial data
5 Pink OUT2 Digital output 2
1)
6 Yellow Reserved Do not use
7 Black TD–/TxD RS-422/RS-232
8 Gray Reserved Do not use
9 Red RD+ RS-422
10 Violet TD+ RS-422
11 Gray/pink Reserved Do not use
12 Red/blue Reserved Do not use
Tab. 9: Pin assignment of the "Data" connection
• Observe the maximum cable length (see "6.1.3 Cable lengths and wire cross-sec-
tions“ on page 46).
• A shielded cable is required for connecting the RS-232 or the RS-422 interface.
• Pre-assembled connection cables with flying leads are available as accessories (see
"12.2 Accessories“ on page 96).
•
1) Digital outputs 1 and 2: The minimum switching time from low to high is 3 ms.
Other connection cables may have different wire colors.
6.2.5 Mini-USB connection of Bullkscan ® LMS511
The Mini-USB Interface permits the direct configuration of the Bulkscan®. The Mini-USB
connection is located on the front of the sensor under a dustprotective cap.
Fig. 31: Position of the Mini-USB connection
• The Mini USB connection is only used for configuration of the sensor and must not
be connected permanently.
• Configuration via USB is only possible if you have installed the USB driver during the
installation of the SOPAS configuration software. This is the case with the default
installation.
• Preassembled connection cables are available as accessories (see "12.2 Accesso-
ries“ on page 96).
• Always screw the dust protective cap back on when you are not using the connection.
Note
Mini-USB connection
Note