![background image](http://html1.mh-extra.com/html/sick/2111696/2111696_mounting-instructions_1264412007.webp)
All rights reserved. Subject to change without notice.
1
About this document
Symbols and document conventions
This document applies to the optics cover with the following part number:
•
2111696
A
,
B
References to the figures at the end of this document are indi‐
cated by a black background.
2
Safety information
WARNING
Incorrect reference value of optical properties
If optics cover calibration is not done correctly, persons and parts of the body to be pro‐
tected may not be detected.
b
Carry out an optics cover calibration with the Safety Designer every time the optics
cover is replaced.
b
Carry out the optics cover calibration at room temperature (10 °C to 30 °C).
b
Only carry out the optics cover calibration using a new optics cover.
b
Make sure that the entire system is clear of contamination when the adjustment is
carried out.
NOTICE
b
The optics cover of the safety laser scanner is an optical component. Make sure
that the optics cover does not become dirty or scratched during unpacking and
mounting. Prevent fingerprints on the optics cover. Wear the gloves supplied with
the new optics cover during replacement.
b
Replace the optics cover in a dry environment free of dust and dirt.
b
Never replace the optics cover during continuous operation, as dust particles
could penetrate into the safety laser scanner.
b
Avoid soiling the inside of the optics cover, e.g, by fingerprints.
b
Do not use any additional sealant, such as silicone, for sealing the optics cover.
Any vapors that are created may damage the optical components.
b
Mount the optics cover according to the following instructions to ensure IP65 leak
tightness of the housing.
b
Only use a new optics cover as a replacement.
b
Provide ESD protection when replacing the optics cover.
NOTICE
Enclosure rating IP65 only applies if the optics cover and the system plug are mounted
and the USB connection is closed with the protective cover.
3
Replacing the optics cover
Fixing screws for the optics cover:
Prerequisites
Tool required:
•
TX10 Torx wrench
MOUNTING INSTRUCTIONS
8024614/2019-11-20 | SICK
M O U N T I N G I N S T R U C T I O N S | nanoScan3 optics cover
7
Subject to change without notice