DATOSPIR TOUCH User’s Manual 16
511-B00-MU2 • REV. 1 .09
2.4 INSTALLATION AND START-UP
This spirometer has been manufactured using solid-state
professional components under strict quality controls. However,
accidents may occur during the transportation or storage of the
equipment and it is therefore wise to initially check its condition
and that of its accessories before installing them.
If you detect any damage to the packaging, contact the
haulier agency and distributor immediately before starting
the installation. Packaging must not be disposed of until the
correct working order of the device has been fully verified.
2.4.1 START-UP
1
Connect the external power supply to the socket no.9,
located on the rear of the device, and to the mains.
The power supply shoud be placed to allow an easy
disconnection for any emergency situation. The disconnection
from electrical main is performed through the plug of the power
supply.
2
Insert the plug of the transducer cord into the socket no.6
3
Connect the other optional modules that you have acquired.
Consult the specific user’s manuals.
4
Press the ON/OFF button (no.3).
5
Choose the language
6
Enter the PIN number, if
equipment protection is
enabled.
See the chapter
3.3 EQUIPMENT PROTECTION.
The first time the equipment is started, the protection is
disabled and the PIN is set to 0000.
7
If equipment protection is not enabled or if the correct PIN has
been entered, the
MAIN MENU
will then be displayed, which
varies according to the model: