18
Step 1. Connect Power
With the motor installed in shade, connect power to the motor 110v
Step 3. Check Directions
Press or . While pressing product should go down or out. To change direction press
and hold (Stop) until shade jogs. A jog is a brief up and down motion.
Step 2. Initiate Programming
Press both and at the same time until the shade jogs. A jog is a brief up and down
motion. In Programming Mode, the shade will move only when the or is held.
Step 4. Set the Limits
Bring the shade to desired upper limit stop point. Press both (Stop) and until the
motor moves, then release. (If the shade stops when the buttons are released take it back to
the upper limit and repeat). Stop the motor when reaching the desired lower limit. You can
adjust by pressing or .
Step 7. Set user mode
Press and hold the programming button on the back of the transmitter until the shade jogs.
The shade is now in User Mode. In User Mode, the shade will operate with a brief press on
or . Double check limit settings as a precaution.
Step 5. Set the Limits
Press both (Stop) and at the same time until the shade moves, then release. The
shade will stop at the original upper limit.
Step 6. Confirm limit settings
Press and hold (stop) unitl the shade jogs to confirm the limit settings. A jog is a brief up
and down motion.
my
my
my
my
my
my
my
my
my
Programming mode
Before you begin
Motors are shipped without limit settings and transmitter ID’s. Steps 1 to 7 must be completed to
ensure proper shade programming and functionality. Power should ONLY be connected to current
shade being programmed. All other shades should be disconnected from their respective power
while programming.
SET LIMITS (MOTORIZED ONLY)
