- 61 -
Primary/Secondary Master/Slave UDMA
Ultra DMA/100 implementation is possible only if your IDE hard drive
supports it and the operating environment includes a DMA driver
(Windows 95 OSR2 or a third-party IDE bus master driver). If both of
your hard drive and your system software support Ultra DMA/100,
select Auto to enable BIOS support.
Ø
The choice: Auto or Disabled.
VIA OnChip PCI Device
Options are in its sub-menu.
Press <Enter> to enter the sub-menu of detailed options.
VIA-3058 AC97 Audio
Enables and disables the onboard audio chip. Disable this item if you
are going to install a PCI audio add-on card.
Ø
The choice: Auto, or Disabled.
VIA-3068 MC97 Modem
Enables and disables the onboard modem. Disable this item if you are
going to install an external modem
Ø
The choice: Auto, or Disabled.
Super IO Device
Options are in its sub-menu.
Press <Enter> to enter the sub-menu of detailed options.
Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDC) in-
stalled on the system board and you want to use it. If you install add-on
FDC or the system has no floppy drive, select Disabled in this field.
Ø
The choice: Enabled or Disabled.
Onboard Serial Port1/Port2
Select an address and corresponding interrupt for the first and second
serial ports.
Ø
The choice: 3E8/IRQ4, 2E8/IRQ3, 3F8/IRQ4, 2F8/IRQ3,Auto, or
Disabled.
UART Mode Select
This item allows you to select which mode for onboard serial port 2.
Ø
The choice: IrDA, Normal, SCR, ASKIR.
