9
What does the RM (Retention Mechanism) consist of
Pentium II processor requires the Retention Mechanism (RM) and optional Heat Sink
Support (HSS) to hold the base processor in the S.E.C. cartridge.
Following installation procedure will display how to install these mechanism.
Retention Mechanism package consists of 2 separate parts and optional Heat Sink Support
consists of 3 separate parts.
Normally, depend on the type of heat sink, Heat Sink Support is not always available. For
some heat sink attached on pentium II processor might not fit to install the Heat Sink
Support. The introduction of Heat Sink Support installation on this manual only for your
reference.
Retention Mechanism (RM) -
Plastic Guide with captive nuts that hold the
S.E.C. Cartridge in the Slot1 connector.
(Refer to Figure 2-3)
RM Attach Mount (RMAM) -
Bolt/Bridge assemblies inserted up through
the bottom of the mainboard. Then secures the
RM to RMAM (two RMAM required per RM).
(Refer to Figure 2-4)
Heat Sink Support Base (HSSBASE) -
Plastic support bar mounted to the mainboard
under the ATX heat sink.
(Refer to Figure 2-5)
HSS Pin (HSSPIN) -
Plastic pins inserted through the HSSBASE to secure
it to the mainboard (two required per Assembly).
(Refer to Figure 2-6)
HSS Top Bar (HSSTOP) -
Plastic bar that clips onto the HSSBASE
through the fins on the ATX heat sink.
(Refer to Figure 2-7)
Figure 2-3
Figure 2-4
Figure 2-5
Figure 2-6
Figure 2-7
