11
Install Pentium™ II Processor
Figure 2-15
Push the latches on the processor toward the center of the processor until they click into place.
Hold the processor so that the fan shroud is facing toward the Heat Sink Support Base bar on
the mainboard. Slide the processor into the Retention Mechanism. Ensure that the alignment
notch in the processor fits over the plug in Slot 1. Push the processor down firmly, with even
pressure on both sides of the top, until it is seated.
Push the latches on the processor outward until they click into place in the Retention Mecha-
nism. The latches must be secured for proper electrical connection of the processor. Slide the
Heat Sink Top Bar (HSSTOP) on the supports forward to clip onto the HSSBASE through the
fins of Heat Sink. (Also refer to "Install Heat Sink Support" section)
Attach the end of the power cable to the three-pin connector on the mainboard or to the power
cord of ATX power supply (depend on power cable type of Fan/Heat Sink).
