Shuttle HOT-637, User Manual

Page: 43 / 45

42
IDE Primary Master UDMA
On this mainboard, Intel PIIX4 improves IDE transfer rate using Bus Master UltraDMA/
33 IDE which can handle data transfer up to 33MB/sec. The options are
Disabled, En-
abled and Auto, Auto is the default settings for on board Primary Master UltraDMA33 .
Note : Your hard drive must also support UDMA for this feature to work.
IDE Primary Slave UDMA
On this mainboard, Intel PIIX4 improves IDE transfer rate using Bus Master UltraDMA/
33 IDE which can handle data transfer up to 33MB/sec. The options are
Disabled, En-
abled and Auto, Auto is the default settings for on board Primary Slave UltraDMA33 .
Note : Your hard drive must also support UDMA for this feature to work.
IDE Secondary Master UDMA
On this mainboard, Intel PIIX4 improves IDE transfer rate using Bus Master UltraDMA/
33 IDE which can handle data transfer up to 33MB/sec. The options are
Disabled, En-
abled and Auto, Auto is the default settings for on board Secondary Master UltraDMA33 .
Note : Your hard drive must also support UDMA for this feature to work.
IDE Secondary Slave UDMA
On this mainboard, Intel PIIX4 improves IDE transfer rate using Bus Master UltraDMA/
33 IDE which can handle data transfer up to 33MB/sec. The options are
Disabled, En-
abled and Auto, Auto is the default settings for on board Secondary Slave UltraDMA33 .
Note : Your hard drive must also support UDMA for this feature to work.
On-Chip Primary PCI IDE
As stated above, your system includes two built-in IDE controllers, both of which operate
on the PCI bus. This setup item allows you either to enable or disable the primary control-
ler. You might choose to disable the controller if you were to add a higher performance or
specialized controller.
On-Chip Secondary PCI IDE
As above for the Primary controller, this setup item you either to enable or disable the
secondary controller. You might choose to disable the controller if you were to add a
higher performance or specialized controller
USB Keyboard Support
This item is used to defined USB Keyboard is Enabled or Disabled .
POWER ON Function
This item is used to defined Keyboard & PS/2 mouse power-on function enabled or
disabled. The options are Button Only , HOT-Key and PS/2 Mouse .
Button Only - Only soft-on/off button on the front panel is available.
Hot-Key
- Power-on by soft-on/off button and keyboard are available. The user may
set power-on hot-key from <Ctrl><F1> to <Ctrl><F12>.
PS/2 Mouse - Powre-on by soft-on/off button and PS/2 Mouse are available.
Note:1. When item of PS/2 Mouse or HOT-Key is selected, please also adjust jumper
JP38 to the proper position. (please refer to page 14)
2. USB keyboard, USB Mouse and Serial Mouse are not supported to this
function.