- 67 -
Suspend --> Off
Monitor is blanked when the system enters
into the suspend mode.
Ø
The choice:
Always On or Suspend ->Off.
Video Off Method
This determines the manner in which the monitor is blanked.
V/H SYNC+Blank This selection will cause the system to turn off
the vertical and horizontal synchronization
ports and write blanks to the video buffer.
Blank Screen
This option only writes blanks to the video
buffer.
DPMS Support
Initial display power management signaling.
Ø
The choice: V/H SYNC+Blank, DPMS Support, or Blank Screen.
MODEM Use IRQ
This determines the IRQ which the MODEM can use.
Ø
The choice: 3, 4, 5, 7, 9, 10, 11, or NA.
Soft-Off by PWR-BTTN
Under ACPI you can create a software power down. In a software
power down, the system can be resumed by Wake UP Alarms. This
item lets you install a software power down that is controlled by the
power button on your system. If the item is set to Instant-Off, then the
power button causes a software power down. If the item is set to Delay4
Sec. then you have to hold the power button down for 4 seconds to
cause a software power down.
Ø
The choice: Instant-Off or Delay 4 sec.
PowerOn by PCI Card
This item Enabled/Disabled PCI Power Management Event to PowerOn
system.
Ø
The choice: Enabled or Disabled.
Power On by Ring
This item determine the system will resume by activating of modem ring.
Ø
The choice: Enabled or Disabled.
USB Wake up
If you are using a USB KB/MS, and the ACPI suspend type is set to S3,
you can enable this item to allow a KB/MS to wake up the system from
power saving mode.
Ø
The choice: Disabled or Enabled.
