- 64 -
POWER ON Function
Enable you to set power on paramenters. The default setting enables
you to use a hot key to turn on the system.
Ø
The choice: Password, Hot KEY, Mouse Move, Mouse Click, Any
KEY, Button Only, Keyboard 98.
KB Power On Password
You can select this item and press " Enter " to input password if power
on function select password.
Hot Key Power ON
When the POWER ON Function is set to Hot KEY, use this item to set
the hot key combination that turns on the system.
Ø
The choice: <Ctrl-F1>~<Ctrl-F12>.
Onboard FDC Controller
This item specifices onboard floppy disk drive controller. This setting
allows you to connect your floppy disk drives to the onboard floppy
connector.
Ø
The choice: Enabled Disabled.
Onboard Serial Port1
This option is used to assign the I/O address and interrupt request ( IRQ
) for the onboard serial port1 ( COM1 ).
Ø
The choice: Disabled, 3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3,
or Auto.
Onboard Infrared Port
This option is used to assign the I/O address and interrupt request(IRQ)
for the onboard infrared port.
Ø
The Choice: Disabled, 3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ, 3E8/IRQ3, or
Auto.
UART Mode Select
This field is available if the Onboard Serial Port 2 field is set to any option
but disabled. UART Mode Select enables you to select the infrared com-
munication protocol-Normal ( default ), IrDA, or ASKIR. IrDA is an infra-
red communication protocol with a maximum baud rate up to 115.2K
bps. ASKIR is Sharp's infrared communication protocol with a maximum
baud rate up to 57.6K bps.
Ø
The choice: SCR, IrDA, ASKIR or Normal.
