- 60 -
Video Off Method
This determines the manner in which the monitor is blanked.
V/H SYNC+Blank This selection will cause the system to turn off
the vertical and horizontal synchronization
ports and write blanks to the video buffer.
Blank Screen
The item only writes blanks to the video buffer.
DPMS Support
Initial display power management signaling.
Ø
The choice: V/H SYNC+Blank, Blank Screen, or DPMS Support.
HDD Power Down
The IDE hard drive will spin down if it is not accessed within a specified
length of time. Options are from 1 Min to 15 Min and Disabled.
Ø
The choice: Disabled or 1 Min~15 Min.
HDD Down In Suspend
The item allows you to enable or disable the HDD Down In Suspend.
Ø
The choice: Enabled or Disabled.
Soft-Off By PBTN
Under ACPI you can create a software power down. In a software
power down, the system can be resumed by Wake UP Alarms. This
item lets you install a software power down that is controlled by the
power button on your system. If the item is set to Instant-Off, then the
power button causes a software power down. If the item is set to Delay
4 Sec., then you have to hold the power button down for 4 seconds to
cause a software power down.
Ø
The choice: Delay 4 Sec. or Instant-Off.
WOL(PME#) From Soft-Off
If this item sets to Enabled, the system power will be turned on when the
LAN port receives an incoming signal.
Ø
The choice: Enabled or Disabled.
WOR(RI#) From Soft-Off
If this item is enabled, it allows the system to resume from a software
power down or power-saving mode whenever there is an incoming call
to an installed fax/modem. You have to connector the fax/modem to
the mainboard.
Ø
The choice: Enabled or Disabled.
USB Resume from S3
If you are using USB devices, and the ACPI Suspend Type is set to S3 or
S1&S3, enable this item to have USB devices wake up the system from
power saving mode.
Ø
The choice: Enabled or Disabled.
