![background image](http://html.mh-extra.com/html/shure/ulx-d/ulx-d_user-manual_1262482007.webp)
7
Back Panel
① RF Antenna Diversity Input Jack (2)
For antenna A and antenna B.
② Power Supply Jack
Connect the supplied 15 V DC external power supply
③ Network Speed LED (Amber)
- Off = 10 Mbps
- On = 100 Mbps
④ Ethernet Port
Connect to an Ethernet network to enable remote control and monitoring
⑤ Network Status LED (Green)
- Off = no network link
- On = network link active
- Flashing = network link active, flash rate corresponds to traffic volume
⑥ Mic/Line Switch
Applies a 30 dB pad in
mic
position (XLR output only)
⑦ Balanced XLR Audio Output
Connect to a mic or line level input
⑧ Balanced 1/4" (6.35 mm) TRS Audio Output
Connect to a mic or line level input
Receiver Output Level
The following table describes the typical total system gain from the audio input to the re-
ceiver outputs:
Receiver Output Gain
Output Jack
System Gain (gain control = 0dB)
1/4" TRS
+18 dB
XLR (line setting)
+24 dB
XLR (mic setting)
-6 dB*
*This setting matches a typical wired SM58 audio signal level.
Transmitters
① Power LED
- Green = unit is powered on
- Red = low battery or battery error (see Troubleshooting)
- Amber = power switch is disabled
② On/Off Switch
Powers the unit on or off.
③ SMA Connector
Connection point for RF antenna.
④ LCD Display:
View menu screens and settings. Press any control button to activate the backlight.
⑤ Infrared (IR) Port
Align with the receiver IR port during an IR Sync for automated transmitter
programming.
⑥ Menu Navigation Buttons
Use to navigate through parameter menus and change values.
exit
Acts as a 'back' button to return to previous menus or parameters
without confirming a value change
enter
Enters menu screens and confirms parameter changes
▼▲
Use to scroll through menu screens and to change parameter
values
⑦ Battery Compartment
Requires Shure SB900 rechargeable battery or 2 AA batteries.
⑧ AA Battery Adapter
- Handheld: rotate and store in the battery compartment to use a Shure SB900
battery
- Bodypack: remove to accommodate a Shure SB900 battery
⑨ Bodypack Antenna
For RF signal transmission.
⑩ Integrated Antenna
For RF signal transmission.
⑪ Microphone Cartridge
See Optional Accessories for a list of compatible cartridges.
⑫ TA4M Input Jack
Connects to a 4-Pin Mini Connector (TA4F) microphone or instrument cable.
௪
௧
௦
௩
௨
௦