![background image](http://html1.mh-extra.com/html/shure/mxa920/mxa920_manual_1261986030.webp)
Shure Incorporated
30/44
1.
2.
3.
4.
1.
2.
3.
4.
Sending Audio from a Shure Device
All AES67 configuration is managed in Dante Controller software. For more information, refer to the Dante Controller user
guide.
Open the Shure transmitting device in Dante Controller.
Enable AES67.
Reboot the Shure device.
Create AES67 flows according to the instructions in the
.
Receiving Audio from a Device Using a Different Audio Network Protocol
Third-party devices:
When the hardware supports SAP, flows are identified in the routing software that the device uses. Oth
erwise, to receive an AES67 flow, the AES67 session ID and IP address are required.
Shure devices:
The transmitting device must support SAP. In Dante Controller, a transmit device (appears as an IP address)
can be routed like any other Dante device.
Paint the MXA920
Painting Square Array Microphones
You can paint the grille and frame of square ceiling array microphones to blend in with a room's design.
Step 1: Remove the Frame and Grille
On each side of the frame, remove the 6 screws and washers that attach the main assembly to the frame.
Important:
Do not remove the 4 recessed screws in each corner.
Carefully lift the assembly out of the frame.
Remove the gray plastic LED lightpipe. Leave the black plastic guide in place.
Remove all 4 recessed screws from one side of the frame. Remove that side of the frame.