Shure EP4T, User Manual

Page: 6 / 12

6
ENGLISH
SPECIFICATIONS
RF Frequency Range
722 to 952 MHz (country dependent)
Operating Range
300 feet (environment dependent)
RF Output Power
50 mW (+17 dBm) typical conducted (country dependent)
Modulation Limiter
Internal peak limiter (>10:1 compression)
Antenna
External whip, 50
Ω
BNC connector
Power Requirements
Operating voltage 14-18 Vdc
Supplied with one of the following external power supplies:
• Model PS40: 120 Vac, 60 Hz input.
• Model PS40E, Model PS40UK: 230 Vac, 50/60 Hz input.
• Model PS40AR: 220 Vac, 50 Hz input.
Current
250 mA maximum
Dimensions
219.2 mm X 43.6 mm X 136.5 mm (8.63 in. X 1.718 in. X 5.375 in.)
Net Weight
907.2 g (2 lbs., 0 oz.)
CERTIFICATION
P4T: Certified to FCC Part 74, FCC ID DD4P4T. Certified in Canada by IC
under RSS-123.
EP4T: Meets essential requirements of European R&TTE Directive 99/5/
EC, eligible to bear CE mark: . Type approved to EN 300 422
Parts 1 and 2. Meets requirements of EMC Standard EN 301 489 Parts 1
and 9.
PS40: Conforms to applicable U.S. and Canadian electrical and safety
standards.
PS40AR: Conforms to Safety Standard IEC 60065. Certified TÜV Rhein-
land Argentina, S.A. No. RA2681022.
PS40E/PS40UK: Conforms to European low voltage directive 72/23/EEC.
Eligible to bear CE marking.
Furnished Accessories
1/4 Wave Transmitter Antenna ................. PA715: 518-752 MHz
...............................................UA400 (95B8699): 774-952 MHz
Bulkhead Adapter.........................................................95A8994
22 inch BNC Cable.......................................................95A2035
Single Mount Rack Bracket ......................................... 53C8484
Dual Mount Rack Bracket.............................................53B8484
Straddle Bars................................................................53A8443
AC Adaptor
PS40 (120V), PS40E (230V), PS40UK (230V), PS40AR (220V)
Optional Accessories
Antenna Combiner ..........................................PA770 (120 VAC)
..................................................................... PA770E (240 VAC)
Unidirectional Antenna..................................................... PA705
10 ft Coaxial Antenna Cable (BNC connector) ................ PA725
CONNECTORS
P4T Audio Inputs (1/L and 2/R) P4T LOOP Outputs (1/L and 2/R)
BAND MIX
MIX OUT 1
MIX OUT 2
P4T TRANSMITTERS (BACK PANELS)
PERSONAL MONITOR MIXER
P4R RECEIVERS
MIXING CONSOLE
BAND MIX
INPUTS 1-4
SPLIT
OUTPUTS 1-4
MIX OUT
MIX OUT 1
(P4M MIX 1)
MIX OUT 2
(P4M MIX 2)
BAND MIX
BAND MIX
DIRECT BOX
DIRECT BOX
O682
Connector Type: 1
/
4
-inch jack (female) TRS
Configuration: electronically balanced
Actual Impedance: 20 k
Ω
Nominal Input Level: -10 dBV/-7.8 dBu
Maximum Input Level: +15 dBu
Pin Assignments: Tip = hot ring = cold
sleeve = ground
Phantom Power Protection? Yes. Up to 50 VDC
Connector Type: 1
/
4
-inch jack (female) TRS
Configuration: electronically balanced
Actual Impedance: 20 k
Ω
Nominal Output Level: -10 dBv/-7.8 dBu
Maximum Output Level: +15 dBu
Pin Assignments: Tip = hot ring = cold sleeve = ground
Phantom Power Protection? Yes
Up to 50 VDC
Operating Two PSM Wireless Systems Under MixMode Control From a P4M Mixer: Send a band mix from a mixing console to a P4T
transmitter, then send the band mix to a second transmitter using the P4T's LOOP OUT feature. Create an individual mix for each trans-
mitter using the P4M mixer. Send the mix to each transmitter using the P4M's MIX OUT 1 or MIX OUT 2 outputs. Use the MixMode control on
the P4R receiver to adjust the levels between the band mix and the P4M mix (for more information on the P4M Personal Monitor Mixer, see
the P4M User's Guide or the PSM 400 Wireless Personal Performance Pack User's Guide, available at ).