3
English –
DP11EQ HARDWARE
Overview
Front Panel
DATA
Ê Ë Ì
Í
Î Ï
Ê
BYPASS Button and LED. Press this button to
suspend all signal processing from the audio path.
When the LED illuminates, the dynamics
processor, delay, and the equalizers are
bypassed.
Ë
SIGNAL LED. Illuminates when input signal is
present. Intensity varies with input signal level.
Ì
CLIP LED. Illuminates when the input signal is
within 6 dB of clipping.
Í
Dynamic Gain Meters. The 7 red LEDs on the left
indicate the reduction in dynamic range, while the
three yellow LEDs on the right indicate dynamic
boost.
Î
DATA LED. This LED indicates that the computer
is communicating with the unit via the RS-232 port.
Ï
POWER LED. LED illuminates when unit is
powered on.
Back Panel
Ñ
Ñ
ÑÑ
Ñ
Ñ
Ñ
ÑÑ
Ñ
Ñ
Ñ
Ñ
Ñ
Ñ
Ñ
Ñ
Ñ
Ñ
Ñ
Ñ
Ñ
Ñ
Ñ
Ñ
Ñ
Ñ
Ñ
Ñ
Ñ
Ñ
Ñ
Ñ
Ñ
Ñ
Ñ
Ñ
Î
Ï
Ì
Ë
Ê
Í
Ê
Power Connector with Integral Fuse. Connects
to AC power. The fuse is located in the drawer
below the connector.
Ë
9-Pin RS-232 Port. Connects the unit to a
computer. For use with DP11EQ software and for
DSP firmware upgrades.
Ì
Shure Link Interface. Allows linking of up to 16
Shure Link compatible devices which may be
accessed by a single computer.
Í
DIP Switches. See
DIP Switches.
Î
Output Connector—
1
/
4
-Inch & XLR. Active,
cross-coupled, balanced outputs can be used with
balanced or unbalanced inputs. Can be switched
b4 dBu/–10 dBV line-level operation by
DIP switch.
1
/
4
-Inch and XLR are driven
independently and either can be balanced or
unbalanced without affecting the other.
Ï
Input Connector—Combined XLR and
1
/
4
-Inch. Active balanced input can be used with
balanced or unbalanced outputs. Can be switched
b4 dBu/–10 dBV line-level operation by
DIP switch.