P/N 1127925 Rev. B
12
STEP 13
: Align holes on wireless receiver
with holes on trailer.
F
asten receiver to trailer with
screws
H
, washers
X
and nuts
R
.
STEP 12
: Install 1 1/2"
rubber grommet into 81mm hole.
Pass
three wires through rubber grommet and align holes
in bracket with drilled holes.
STEP 14
: Drill hole in location shown and install rubber grommet
with 14mm
ID
(grommet not supplied)
.
SMART3™ Wireless Receiver
- continued
rubber
grommet
three
wires
hole
in
bracket
drilled
hole
hole
in
trailer
wireless
receiver
grommet
STEP 11
: Pull all three wires out of rubber grommets on bottom
of receiver bracket.
Insert two 1" plugs into rubber
grommets.
Verify wire lengths before drilling holes. Dual-con
-
ductor red (+) and black (-) wire must reach 24V DC
power supply. Two marked 3-conductor wires must
reach junction boxes on spool motor or center pole
drive motor. Observe full motion of center pole motor
and supply enough wire for motor to reach fully open
and closed sheet positions.
H
X
R
Summary of Contents for SHUR COVER
Page 1: ...Sheeting System w SMART3 P N 1127925 Rev B ...
Page 24: ......
